Differences

This shows you the differences between two versions of the page.

--- start:onboarddyne [2025/03/31 18:17] – created mcopeland
+++ start:onboarddyne [2025/04/01 19:53] (current) – mcopeland
@@ Line 1: / Line 1: @@
-**Configuration of DVR at Dyne location**
+**Dyne Hik-Vision DVR configuration**
+  - Open the DVR page eg: http://50.196.110.245:10080/doc/index.html#/preview in an IE-tab window.
+  - Click on Configuration on the top bar
+  - Under basic information, set the device name
+  - Click on Time Settings and ensure the time and timezone are correct. Set the NTP server address to time.windows.com, NTP port 123, interval 60.
+  - Under Network, ensure the correct IP information is set for the DVR. Use the reference image below and match the information to the Network settings.
+{{:start:dyne_network_settings.png?400|}}
+  -Under Configuration > User Managment add the following users:
+  -office:Support1
+  -areamgr:Areamgr1
+  -
+----
+Under Network - Advanced - Enter the following email settings.
+Sender – Relabel to site name.
+Sender’s Address – kerrsur@gmail.com
+SMTP Server – smtp.gmail.com
+SMTP Port – 587
+Click both Enable SSL and Attached Image
+Interval - 5s
+Username – kerrsur@gmail.com
+Password - xlfbfrquwwbpijlc
+Receiver – Kerr Surveillance Help Desk
+Receiver’s Address – help@kerrsurveillance.com
+Platform Access – Disable encryption code when applicable.
+------------------------------------------------------------
+**Video Settings**
+Video/Audio
+Video – You will need to check both the Main and Sub- streams.
+Video Type – Ensure each Channel No. is set to the proper type. If IP cameras, select “Video & Audio.”
+Resolution – Should be the highest option possible.
+Bitrate – Variable
+Video Quality - Higher
+Frame Rate – Should be set at 20 for Main and Full Frame Rate for Sub
+Video Encoding – H.265 when applicable.
+H.264+/H.265+ - OFF
+Channel-zero – Disabled
+--------------------
+**Other Settings like Image, OSD(On Screen Display)**
+Image
+OSD Settings – This is where you will label each camera.
+Event
+Video Loss – Click Enable Video Loss Detection and Send Email under the Linkage Method on each channel.
+Exception – Enable Send Email for all Exception Types (EXCEPT HDD Full and Illegal Login). Disable all Audible Warnings.
+Storage
+Schedule Settings – Ensure each channel has recording enabled. If audio, you will have to click Advanced to ensure Record Audio is enabled as well.
+Storage Management – This is where you will format the hard drive and check the status of it.