Kerr Technologies Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== DYNE - Onboarding Checklist ======



  *** Pre-Installation Procedures:**  
           * Verify and add store information into master list 
                       * Address
                       * Phone number                 
                       * Store ID
                       * District manager
                   {{ :start:screenshot_2026-05-29_125849.png?600 |}}
           * Determine which project components will be installed
                       *How many cameras needed, 8 or 16 channel DVR, etc. - you can determine which DVR you will need by the amount of cameras you need, 8+ cameras means 16 channel DVR
                     {{ :start:screenshot_2026-05-29_130429.png?600 |}}
           * Create CompanyCam project
                  {{ :start:screenshot_2026-05-29_131045.png?600 |}}

           * Obtain and screenshot blueprints & marked up blueprints
                       * Speakers, cameras and Wi-Fi locations
                       * Upload to CompanyCam
                  {{ :start:screenshot_2026-05-29_131506.png?600 |}}    
           * Schedule technician
                       * Use Field Nation
                       * Make sure they have what they need.
          
           * Order any necessary parts
                       * NVR
                       * Hard Drive
                       * Cameras
                       * Cabling
           
           * Confirm parts delivery



** On-Site Procedures:**
           * Take "before" photos
           {{ :start:screenshot_2026-05-29_132814.png?600 |}}
           * Confirm parts/equipment on site
                       * Camera equipment
                       * Music equipment
                       * Spectrotel equipment
          
           * Install Spectrotel
           
           * Run cabling
           
           * Install components
                       * MOOD
                       * Cameras
                       * Wi-fi access points 
          
           * Set up remote session with project manager
           
           * Test/confirm components
           
           * Take "after" photos



  * Post-Installation Procedures:
           * Add to DVR checks & appropriate weekly DVR checks
           * NVR configurations
           * Provide camera access to provided list of employees
           * Complete CompanyCam final reports
           * Upload Live View comparison photos to the wiki
           * Get OOP cost from tech
           * Notify Brian that they are ready to be billed