**Dyne Hik-Vision DVR configuration**

  - Open the DVR page eg: http://50.196.110.245:10080/doc/index.html#/preview in an IE-tab window.
  - Click on Configuration on the top bar
  - Under basic information, set the device name
  - Click on Time Settings and ensure the time and timezone are correct. Set the NTP server address to time.windows.com, NTP port 123, interval 60.
  - Under Network, ensure the correct IP information is set for the DVR. Use the reference image below and match the information to the Network settings.

{{:start:dyne_network_settings.png?400|}}

  -Under Configuration > User Managment add the following users:
  -office:Support1
  -areamgr:Areamgr1
  -
----
Under Network - Advanced - Enter the following email settings.

  

Sender – Relabel to site name.  

Sender’s Address – kerrsur@gmail.com 

SMTP Server – smtp.gmail.com 

SMTP Port – 587 

Click both Enable SSL and Attached Image 

Interval - 5s 

Username – kerrsur@gmail.com	 

Password - xlfbfrquwwbpijlc 

Receiver – Kerr Surveillance Help Desk 

Receiver’s Address – help@kerrsurveillance.com 

Platform Access – Disable encryption code when applicable. 

------------------------------------------------------------
**Video Settings**


Video/Audio 

Video – You will need to check both the Main and Sub- streams.  

Video Type – Ensure each Channel No. is set to the proper type. If IP cameras, select “Video & Audio.” 

Resolution – Should be the highest option possible.  

Bitrate – Variable 

Video Quality - Higher 

Frame Rate – Should be set at 20 for Main and Full Frame Rate for Sub  

Video Encoding – H.265 when applicable. 

H.264+/H.265+ - OFF 

Channel-zero – Disabled 
--------------------
**Other Settings like Image, OSD(On Screen Display)**

Image 

OSD Settings – This is where you will label each camera. 

Event  

Video Loss – Click Enable Video Loss Detection and Send Email under the Linkage Method on each channel.  

Exception – Enable Send Email for all Exception Types (EXCEPT HDD Full and Illegal Login). Disable all Audible Warnings.  

Storage  

Schedule Settings – Ensure each channel has recording enabled. If audio, you will have to click Advanced to ensure Record Audio is enabled as well.  

Storage Management – This is where you will format the hard drive and check the status of it.