Kerr Technologies Wiki

Dyne Hik-Vision DVR configuration

Open the DVR page eg: http://50.196.110.245:10080/doc/index.html#/preview in an IE-tab window.
Click on Configuration on the top bar
Under basic information, set the device name
Click on Time Settings and ensure the time and timezone are correct. Set the NTP server address to time.windows.com, NTP port 123, interval 60.
Under Network, ensure the correct IP information is set for the DVR. Use the reference image below and match the information to the Network settings.

—- Under Network - Advanced - Enter the following email settings.

Sender – Relabel to site name.

Sender’s Address – kerrsur@gmail.com

SMTP Server – smtp.gmail.com

SMTP Port – 587

Click both Enable SSL and Attached Image

Interval - 5s

Username – kerrsur@gmail.com

Password - xlfbfrquwwbpijlc

Receiver – Kerr Surveillance Help Desk

Receiver’s Address – help@kerrsurveillance.com

Platform Access – Disable encryption code when applicable.

Video Settings

Video/Audio

Video – You will need to check both the Main and Sub- streams.

Video Type – Ensure each Channel No. is set to the proper type. If IP cameras, select “Video & Audio.”

Resolution – Should be the highest option possible.

Bitrate – Variable

Video Quality - Higher

Frame Rate – Should be set at 20 for Main and Full Frame Rate for Sub

Video Encoding – H.265 when applicable.

H.264+/H.265+ - OFF

Channel-zero – Disabled

Other Settings like Image, OSD(On Screen Display)

Image

OSD Settings – This is where you will label each camera.

Event

Video Loss – Click Enable Video Loss Detection and Send Email under the Linkage Method on each channel.

Exception – Enable Send Email for all Exception Types (EXCEPT HDD Full and Illegal Login). Disable all Audible Warnings.

Storage

Schedule Settings – Ensure each channel has recording enabled. If audio, you will have to click Advanced to ensure Record Audio is enabled as well.

Storage Management – This is where you will format the hard drive and check the status of it.